Site Assumptions

Site Assumptions for Glass or Mirror Assemblies

To Measure, Supply and Install to your suitably prepared solid grounds, walls, columns, openings, channels etc. It is assumed that such prepared openings are true, level and structurally sound to accept your Specified Glass Assembly.

Uninterrupted site access to carry out installation of Glass System, based on Clients Design and Structural Specification, unless stated Creative Glass & Mirrors Ltd. do not accept any responsibility for Design or Structural Engineering Load Calculations.

Unless otherwise stated, work will be carried out during normal Working Hours – Monday – Friday 8.30AM to 16.30PM.Any works carried out after the duration of this period will be charged to the client at the standard rate of Overtime for Creative Glass.

All other specialist works E.G. Electrical, is responsibility of Client, unless otherwise stated.

Glass Doors and Fixed panels supplied in toughened glass with exposed edges polished, it is not possible to fully draughtproof such assemblies.

Glass is measured allowing tolerances for installation, processed glass is cut and processed in accordance with GGF tolerances and recommendations, Toughened Glass may have varying degrees of surface distortion, caused by this heat based process.

All cut-outs in the floor for Floorspring Boxes are the responsibility of the Client.

Please check that we have interpreted your drawings and instructions correctly, as differences in detail or size after site inspection, may require revision to our quoted price. All Quotations and Orders received are subject to Creative Glass & Mirrors Ltd. Terms & Conditions of Sale.(see attached)

Glass Bends
In accordance with Industry Standards, the Tolerances on Glass Bends are +/- half the thickness of the glass to a maximum of +/- 6mm.Toughened Glass is subject to surface distortion as outlined above.

The fixed panel to be set in aluminium U channel to fit your suitable recessed cut-outs to the floor, walls and soffit.

Laminated Glass
Size variations are in accordance with Glass and Glazing Federations Standards.
The process often uses clear tape around the outside edges (and any holes requested); this junction between the tape and the resin creates a visible minimal shadow line, and can also cause minor bubbles in this margin. Minor bubbles can also be present in the body of each panel, but should not exceed two per square metre. Slight distortion to transmission can be evident through the processes of laminating and toughening, Site inspection should be from a distance of 3m.

Decoration / Redecoration.
Creative Glass cannot be held responsible for Decoration/Redecoration of immediate work area, all efforts will be made to clean the work area and leave it in a clean condition.

Colour Coated Glass
Due to the iron content naturally found within glass we cannot guarantee exact colour matches. However we will endeavour to match any colours or samples received as precisely as possible.

To reduce the amount of iron content and when using lighter colours we would recommend using Low Iron glass. This will ensure a more accurate colour match. Low iron may be subject to additional costs at the time of ordering.